Rocky Roads, Custom Ford Broncos  
   
 

1966 Coyote Bronco Legend uncut or cut w12" coil over suspension

Year: 1966 Color: your color choice Price: $159,000
Updated: 11/30/2017 9:07:10 PM
Engine: 430HP Coyote engine
Transmission: 4R70W 4 speed automatic , Atlas 2 Transfer case
Exterior: Custom Paint , Match Painted Flares , Restored Hardtop , Rocky Roads Cowl Induction hood , Rocky Roads rear bumper with swing out tire carrier , Legend front bumper with push bar , Wire brush prepped & Undercoated , factory antenna , New lights and lenses , New windshield and seal , Removable door hinges
Interior: Legend 6 point family roll cage , tilt column , power windows , Custom Legend dash , Dakota Digital Insturment cluster , Vintage Air system , vinyl tailgate panel , vinyl rear side panels , vinyl door panels , RR Billet dash knobs , Tuffy locking center console , Rear seat , Shoulder belts , Custom snap in-and-out carpet mats
Brakes: 17" Wilwood 4 wheel disc brakes , Hydroboost
Steering: Tom Lee 3.2 turn P.S system
Suspension: King 2.5" Coil-over shocks , 2" body lift , 2.5" Lift , Rear sway bar , Front sway bar
Features: 10" woofer box under rear seat w/600W amplifier , Custom Stereo , component speakers
Electrical: New custom wire harness
Tires: 33" all terrains
Wheels: Black Fuel 17x9" wheels
Fuel System: 23 gallon F.I. fuel tank
axles: Dana 44 w/ limited slip , 4.56 gears , currie 31 spline axles , Big bearing Ford 9"
This 1966 Ford Bronco will be our next Coyote Bronco "Legend" model with 12" coil-over four link suspension with King dual-rate coil over shocks. This 100% rust-free Classic Ford Bronco has a clean CA title and a pristine condition 1966 Classic Ford Bronco frame, which has already been sent out for sand blasting.

We just ordered a new Marti Report for this Bronco, including brand new window sticker describing everything this Bronco came with from the factory, new VIN plate to go inside of glove box, and new VIN sticker for inside of the drivers side door.

This Bronco could look similar to the 'cut and flared' Bronco in the set of pictures with the larger tires and wheels, or the 'uncut' Bronco in the other set of pictures. It can have your favorite wheels, tires, bumpers, leather seating and interior paneling, roll cage, you can make just about any choice you want to make on this build right now while it's still in the beginning stages of the build.

So far, the frame has been sand blasted, and is out at the fab shop having the new 12" coil-over Legend suspension system custom fitted to the frame. A brand new Currie Enterprises Dana 44 front axle is now here. Same goes with the brand new Currie heavy duty Ford 9" rear axle. These axle housings are now being fitted to our Legend 12" coil over suspension.

Once this process has been completed, we will remove the axle housings and all the suspension, then send everything out to be powder coated satin black. This Bronco is now well on it's way to becoming our next Coyote Bronco "Legend" model.

Our recently featured Legend Bronco #2 had our unique 12" four linked coil-over suspension system with front & rear sway bars that worked really well, however this one is going to have our re-designed Legend 12" coil-over suspension system with larger 1.25" ball joints & steering which will be improved from our earlier models.

It's performance will surpass anything being built on a stock Early Bronco chassis today. Bronco Driver magazine recently featured our 2nd Legend Bronco, you can check out the recent 9 page feature on the 1974 Arctic Blue Legend page in the for sale section.

King Shock Technologies will provide the 2.5"X 12" front & rear Racing shocks for this Coyote Legend Bronco. Eibach will provide the front & rear coil-over springs. This suspension will allow 12" of front wheel travel & 12" of rear wheel travel. We will be installing custom front & rear sway bar systems to make this Bronco handle as good as it can with that incredibly soft and capable suspension.

Our new Legend 12" Coil-over four link suspension system is arguably the softest suspension system you can install on a Vintage Bronco today. It goes over bumps like nothing else you have ever felt in any Early Bronco. We now have built 10 new Legend 12" coil-over suspension systems, which are now available for sale for those who want to have the softest suspension system possible on their Bronco.

Here are some of the features this Coyote Legend Bronco will have on it:

* 430HP Ford Coyote 5.0 liter aluminum crate engine, serpentine belt system, hi output alternator, hi volume water pump, high output power steering pump, new air compressor & all brand new top-of-the-line engine parts surrounding the engine

* Custom stainless headers & "quiet" Borla custom stainless dual exhaust system

* 4 speed automatic 4R70W transmission with all top-of-the-line parts, built to hold up to 700 HP. (OR new 6 speed automatic transmission for an additional $5,500.00)

* Brand new aluminum Atlas 2 aluminum transfer case (3.0 ratio) with twin stick shifters

* Custom RR built transmission cross member

* Custom Coyote motor mounts

* Custom transfer case cross member & skid plate

* New Tom Woods custom length drive shafts

* Currie heavy duty Ford 9" rear axle

* ARB Air Locker in back with 4.11 gearing with new 31 spline axles, bearings & seals

* New Currie Dana 44 front axle with new knuckles and ball joints

* Front ARB Air locker, heavy duty chromoly axles, all new bearings & seals

* New high torque starter wrapped with insulation to protect it from heat

* New 23 gallon fuel tank customized for fuel injection with a heavy duty steel skid plate

* Powder coated tilt steering column with custom Burlwood steering wheel

* New stainless steel steering shaft with stainless u-joints

* New power steering pump & brackets

* New 4 turn power steering steering gear box

* New Hydro-boost brake system

* Wilwood 4 piston caliper 4 wheel disc brakes

* New stainless steel custom brake lines throughout

* King Shock Technologies 2.5" coil-over custom valved shocks with 12" wheel travel in front & 12" in back

* Eibach 2.5" dual rate coil springs in front, with dual rate coil springs in back

* Custom Sway Away front & rear sway bars

* MHT Fuel 17x9" black aluminum wheels (or 17x7" smooth Retro wheels if uncut)

* 5 new BFG 305/65R17 Mud Terrain KM-2 tires (OR 285/65R17 tires if uncut)

* Rocky Roads Cowl Induction fiberglass hood with hood shocks & metal rails if cut and flared, (stock steel hood if uncut)

* High quality paint job with match painted fender flares & bumpers OR uncut fenders

* Custom Legend dash with heater and A/C vents in or under dash

* All new dash hardware & bezels

* Custom A/C system with 4 round in-dash A/C vents in-dash with built in heater system

* Dakota Digital in-dash climate control system

* Dakota Digital VHX carbon fiber blue-lit speedometer OR Classic Instruments analog or digital speedometer

* New Amp Research retractable power steps with LED lights

* 7" Apple CarPlay head unit with Alpine 5 channel amp with 600 W of power

* 12" Alpine woofer console under the rear seat w/ 8 Alpine component speakers

* Legend pleated vinyl front seats pattern-matched to a stock Early Bronco rear seat or fold 'n tumble rear seat with head rests

* Legend family 6 point roll cage with retractable front & rear seat belts, padding & wrapping & new Grade 8 mounting hardware

* Black Tuffy locking center console & locking glove box, match keyed

* New Polyurea interior bed liner (Linex) with black snap-in carpet mats front & rear

* Black chrome outer door handles & inner door handles, black chrome door mirrors

* New 12 pc window anti-rattle kit & all new internal & external door parts

* Power windows & power door locks

* New windshield glass & seal, custom rear view mirror with back up camera

* New driver & passenger door glass, wing windows & all new rubber throughout

* Grade 8 & stainless steel hardware throughout

*Brand new Rampage black vinyl soft top & custom bikini top

(Custom painted hard top with tinted side slider windows available for an additional $5,000.00)

You can still custom order this Bronco to your exact specs or we can go over everything with you (for as long as you want until you feel comfortable) and come up with a Coyote Bronco "Legend" model that fits your style and your budget. Cut and flared or Un-Cut, it can still be your choice. Completion date estimated at 6-8 months from date of deposit.

Price of this Coyote Bronco "Legend" model starts at $159,000.00 and could go as high as $169,000.00 depending on what features you want.

ADD $4,500.00 for UV protected Leather in 1 of 10 colors on seating and interior paneling

Call Shaun for more information and pricing 310-293-7801. We can email you a private proposal if you fill out our customer information sheet we can send you.
11/29/2017 - OR it could look like this, but in your color choice
10/25/2017 - It could look like this in your color choice
Rocky Roads Facebook
Copyright © 2017.  Web Hosting / SEO by DEENT.