Rocky Roads, Custom Ford Broncos  

1966 Coyote Legend Bronco 430 HP with coil over suspension

Year: 1966 Color: Your color choice Price: $0
Updated: 10/27/2019 2:27:16 PM
Engine: Coyote 5.0 liter 430HP engine , Serpentine belt system , aluminum valve covers , aluminum radiator , Modified Ignition , Modified Exhaust System , Modified Headers , Modified Manifold , Modified Air Filter
Transmission: 4R70W 4 speed automatic , Atlas 2 Transfer case , Shifter on the column
Exterior: Custom Paint , Restored Hardtop , Custom Bumpers , New windshield and seal , New lights and lenses , Amp Research side steps , Rock Solid rear bumper with tire carrier , Legend front bumper with push bar , Wire brush prepped & Undercoated , factory chrome mirrors
Interior: Linex , Custom high back seats , Legend 6 point family roll cage , tilt column , Custom Legend dash , Dakota Digital Insturment cluster , Vintage Air system , vinyl tailgate panel , vinyl rear side panels , vinyl door panels , Tuffy locking center console , Custom snap in-and-out carpet mats , Shoulder belts
Brakes: Modified All Disc , Hydroboost , New Master Cylinder , New Lines
Steering: 4 Turn Power Steering , Modified Steering Wheel , Modified Power Steering
Suspension: King 2.5" Coil-over shocks , Four Link front & rear
Features: Custom Stereo
Electrical: New Centek wire harness , New Odyssey red top battery
Tires: 305/65R17 BFG Mud Terrains
Wheels: Hutchinson 17" run flats
Fuel System: 23 gallon F.I. fuel tank
axles: Dana 44 w/ limited slip , limited slip Ford 9" , 4.11 gears
This 1966 Coyote Legend Bronco is currently being restored. Upon completion, this Coyote Legend Bronco will be brand new throughout.

It already had the entire suspension cut off and new 12" coil-over Legend suspension installed. It has new 2.5" King 12" coil-over shocks and Eibach coil springs in front, with rear trailing arms, 4 link, and 2.5" King shocks and Eibach springs in back, plus all new bump stops and limiting straps. There will be sway bars in front and in back to make it handle excellently either on the road or off road.

It is scheduled to be completed mid-2020, before the new 2020 Bronco hits the market. This Bronco is 100% rust free, the 'all new' steel Ford Bronco body was built using Licensed Ford parts. We will be installing a Rocky Roads Cowl Induction fiberglass hood with hood struts to improve air flow into the engine bay, and protect against future rust by allowing air into the air vents, while preventing water from entering into the air vent system.

This Bronco has not been painted yet, you could still choose the color. It will get a black Polyurea (Linex) interior bed liner and will be fully under coated. It can still have any wheel and tire combo you want.

We can either keep it UNCUT and go with smooth retro 17" or 18" wheels and 285/65R17 tires, or we could cut the fenders and install new match painted fender flares in front and in back to accommodate 305/65R17 BFG All Terrain tires and 17x9" black MHT wheels. It will receive all new grade 8 and stainless steel hardware throughout the build.

This is our most recent 430HP Coyote Bronco build with a 4R70W four-speed automatic transmission, backed up with an Atlas 2 3.0 ratio two speed shift-on-the-fly transfer case. Everything in the braking system will be new and top of the line.

The new Currie Dana 44 front axle housing will have 4.11 gears with a soft locker in front, plus a new Currie Ford 9" housing with a posi-traction unit, both will have new hardened axles, new bearings, seals etc. We will be installing new 4 wheel disc brakes, along with a Hydro-boost braking system.

The interior will be new diamond stitched or pleated Legend high back back bucket seating in front, the rear seat will either be a factory rear seat or a folding rear seat with head rests. It will have pleated vinyl door, rear side and tailgate paneling, plus new snap-in carpet mats throughout. A black locking center console will house a new Alpine head unit that has bluetooth, with a speakerphone system. There will be 4 FoCal component speakers in the rear side panels, and 4 more in the front kick panels, powered by a 5 channel Alpine amplifier with a new Centek wire harness, plus a new RR woofer console with a 12" Alpine sub woofer inside (mounted with our raiser brackets underneath the rear seat) with Baja Designs 20" stealth light bar in front, 2 back up lights in back for reverse lighting, plus an interior LED light and LED lights throughout.

It is getting a new RR Legend 6 point roll cage, powder coated black, with retractable front and rear seat belts, plus Legend Hybrid front bumper with push bar in front, it will get a new Rock Solid rear bumper, powder coated black.

The dash will be a custom Legend dash with new head light switch, new wiper switch, a new blue-lit Dakota Digital speedometer, with 2 round air conditioning vents in-dash, 2 rectangular vents on the sides of the dash, plus a new Vintage Air system. The glove box will be either a black locking glove box or a stock Bronco glove box.

More information coming soon.

Call Shaun for pricing 310-293-7801
10/27/2019 - New body and Legend suspension installed
Rocky Roads Facebook
Copyright © 2019.  Web Hosting / SEO by DEENT.